NEC ELECTRA ELITE IPK II - Charging Unit Wall Mounting

Electra Elite IPK II Document Revision 3
System Hardware Manual 13 - 25
___________________________________________________________________________________
___________________________________________________________________________________
8.8 Charging Unit Wall Mounting
The charging unit can be wall mounted. Before installing, consider the
following:
J Select a location away from electrical cables, pipes, or items behind the
mounting location that could cause a hazard when inserting screws.
J Make sure the wall material can support the weight of the charging unit.
J Use #10 screws with anchoring devices suitable for the wall material.
To mount the charging unit:
1. Insert two mounting screws one inch apart. Allow about 3/16 of an inch
between the wall and screw heads for mounting the telephone.
2. Plug the AC adapter in the charging unit. Wrap the AC adapter cord
around the strain relief.
Figure 13-22 Inserting Screws for Wall Mounting
Figure 13-23 Wrapping AC Adapter Cord Around the Strain Relief Clip
1 3/16 in.
3/16 in.
TOP
Strain
Relief