NEC ELECTRA ELITE IPK II - Installing Add on Module (ADM); Connecting the Interface Unit

Electra Elite IPK II Document Revision 3
System Hardware Manual 9 - 61
___________________________________________________________________________________
___________________________________________________________________________________
J Password
Locks access to these settings and those at the user level.
 When making changes, the application must be closed and
started again to become effective.
3.10 Installing Add on Module (ADM)
The D16(LD)-R ADM creates a 16 button Phonebook directory. The interface
for this unit shown in Figure 9-62 ADM Interface Unit is connected in the right
adapter connector for the applicable multiline terminal. When another adapter
needs to be added, this interface must be moved to the left adapter connector
to preserve the cable integrity.
3.10.1 Connecting the Interface Unit
1. Set DSW1 to the pattern for the applicable multiline terminal as
shown in Table 9-12 DSW1 Switch Positions on the next page.
2. Place the ADM and multiline terminal upside down and remove
the Base Units.
Figure 9-62 ADM Interface Unit
1
2
3
4
5
6
7
8
O
N
3
1
DSW1
Position
ON
DSW1
1 2 3 4 5 6 7 8