NEC ELECTRA ELITE IPK II - Switch Settings

___________________________________________________________________________________
11 - 12 Installing Electra Elite Optional Terminal Equipment
___________________________________________________________________________________
Document Revision 3 Electra Elite IPK II
3.2.3 Switch Settings
The DIP Switch is located at the bottom center of the ADA-U Unit.
The DIP Switch allows a technician to configure the board to specific
settings. Figure 11-14 ADA-U Unit Switch Settings shows the default
settings.
The following switch settings should be made on the ADA-U Unit to
enable or disable the record start warning tone. Switch settings
should be made before installing the ADA-U Unit in the Multiline
Terminal. Refer to Table 11-2 ADA-U Unit Switch Settings.
Figure 11-14 ADA-U Unit Switch Settings
Table 11-2 ADA-U Unit Switch Settings
Switch Setting Description
SW1–1 On When the ADA-U provides control to the
recorder, SW1-1 should be set to On,
otherwise set it to Off.
SW1–2 Off Leave Off
Default Settings
Terminals
Dip Switch