NEC ELECTRA ELITE IPK II - Wall Mounting ADM and Multiline Terminal

Electra Elite IPK II Document Revision 3
System Hardware Manual 9 - 63
___________________________________________________________________________________
___________________________________________________________________________________
6. Replace the base units as shown in Figure 9-63 ADM and
Multiline Terminal with Base Covers Removed.
3.10.2 Wall Mounting ADM and Multiline Terminal
1. Remove both Base Units.
2. Remove the Multiline Terminal Base Unit cutout shown in
Figure 9-65 Installing Base Units on the Wall.
3. Install the base units on the wall using the eight screws.
4. Install the ADM and Multiline Terminal as shown on Figure 9-63
ADM and Multiline Terminal with Base Covers Removed.
Figure 9-64 Installing the Connector Plate