NEC ELECTRA ELITE IPK II - Connectors; LED Indications

Electra Elite IPK II Document Revision 3
System Hardware Manual 6 - 37
___________________________________________________________________________________
___________________________________________________________________________________
5.5.4 LED Indications
Refer to
Table 6-12 COIB(4)-U20 ETU LED Indications.
5.5.5 Connectors
The following connectors are included:
J CN1 Connects to the backplane.
J CN2 Future
J CN3 Future
S1
Open for COI
Shorted (default) for COID
Selects COIB(4)-U20
ETU COI or COID
mode.
Reset Toggle
Resets the
COIB(4)-U20 ETU
Table 6-12 COIB(4)-U20 ETU LED Indications
LED Description On Flashing Off
LIVE ETU status
Operation
Stopped
(Power On)
Normal
Operation
No
Power
LED 1 Channel 1 status Busy Not Used Idle
LED 2 Channel 2 status Busy Not Used Idle
LED 3 Channel 3 status Busy Not Used Idle
LED 4 Channel 4 status Busy Not Used Idle
FAX FAX status Busy Not Used Idle
Table 6-11 COIB(4)-U20 ETU Default Switch/Jumper Settings
Switch/
Jumper
Setting Description