NEC ELECTRA ELITE IPK II - Installing the PS(A)-R Unit

___________________________________________________________________________________
9 - 42 Installing Electra Elite IPK II Optional Terminal Equipment
___________________________________________________________________________________
Document Revision 3 Electra Elite IPK II
3.8.6 Installing the PS(A)-R Unit
1. Turn over the ITR terminal, remove the LAN and headset
cables, and disconnect the AC adapter when it is being used.
2. Raise the Base stand in the direction of the arrow until it locks
in the fully expanded position.
Table 9-11 Volume/Contrast Display Using PSTN Line
Volume/
Contrast
Display
HANDSET None [Volume is controlled by PS(A)-R.]
SPEAKER None (Cannot be used for PSTN line.)
RING None [Volume controlled by PS(A)-R switch.]
OFF-HOOK
RING
None (Cannot be used for PSTN line.)
LCD LCD contrast
BGM None (Not Used)
Figure 9-40 Raise the Base Stand