NEC ELECTRA ELITE IPK II - Switch Settings

Electra Elite IPK II Document Revision 3
System Hardware Manual 11 - 15
___________________________________________________________________________________
___________________________________________________________________________________
3. Close the base plate, and snap the cover in place.
4. Install a ferrite core (provided with the APA-U Unit) by looping
line cord through the core between the terminal (one inch from
the terminal) and ESI(8)-U10 ETU. This core is only used with
the APA-U Unit.
5. Plug the telephone cord in the jack.
3.3.2 Switch Settings
The APA-U Unit has one switch.
Figure 11-16 Attaching the Unit to the Multiline Terminal
Figure 11-17 APA-U Unit Switches