NEC ELECTRA ELITE IPK II - Installing the Wall Mount Unit and Mounting the Multiline Terminal Using the WMU-U Unit

Electra Elite IPK II Document Revision 3
System Hardware Manual 11 - 35
___________________________________________________________________________________
___________________________________________________________________________________
11. When properly installed, the wall-mounted Multiline Terminal
looks similar to the one shown in Figure 11-45 Installed Wall
Mount Unit.
 Do not adjust the tilt panel after the Multiline Terminal is
mounted on the wall.
3.9.3 Installing the Wall Mount Unit and Mounting the Multiline Terminal
using the WMU-U Unit
When installing any Adapter unit, a separate WMU-U Unit must be
purchased to accommodate this unit.
1. Remove the line cord, base plate and base cover from the
Multiline Terminal as shown in the previous section.
2. Cut off the tabs on the adapter as shown in Figure 11-46
Removing the Tabs from the Adapter.
Figure 11-45 Installed Wall Mount Unit