NEC ELECTRA ELITE IPK II - Installing Line Cards and Plastic Panels

Electra Elite IPK II Document Revision 3
System Hardware Manual 8 - 37
___________________________________________________________________________________
___________________________________________________________________________________
14.4 Installing Line Cards and Plastic Panels
Line key designations are entered on a line card that is placed on the terminal
to provide quick line-key reference. The line card can be changed when
necessary. The plastic panel is placed on top of the line card to hold it in
place. To change line card:
1. Refer to Figure 8-49 Removing Plastic Panel, and lift up on the plastic
panel to remove it.
2. Refer to Figure 8-50 Installing New Line Card, and place new line card
over the keys on the Terminal.
Figure 8-49 Removing Plastic Panel
Figure 8-50 Installing New Line Card