NEC ELECTRA ELITE IPK II - Installing Hard Drive on the VMP( )-U40 ETU

Electra Elite IPK II Document Revision 3
System Hardware Manual 6 - 125
___________________________________________________________________________________
___________________________________________________________________________________
7.5.4 Installing Hard Drive on the VMP( )-U40 ETU
Warning! Handle the hard drive carefully! Do not drop the drive or
apply pressure to it! Do not touch the printed circuit board of the
drive or ETU unnecessarily. Doing so can make a drive inoperable!
This unit makes extensive use of CMOS technology that is very
susceptible to static; therefore, extreme care must be taken to avoid
static discharge when handling.
1. Before mounting the drive make note of the connection to the
hard drive, notice the four pins to the left of the drive. These
pins are not connected for normal operation. Refer to
Figure 6-70 Connecting the Hard Drive.
2. Check jumper J-7 and make sure it is on pins 2-3. Refer to
Figure 6-71 Plus Sign on Battery Displayed Up.
Figure 6-70 Connecting the Hard Drive