NEC ELECTRA ELITE IPK II - Installing the CT(U)-R Unit

___________________________________________________________________________________
9 - 24 Installing Electra Elite IPK II Optional Terminal Equipment
___________________________________________________________________________________
Document Revision 3 Electra Elite IPK II
This adapter can be installed on any Multiline Terminal except the DTR-2DT-1
TEL and ITH-8D/16D-2.
Figure 9-25 Connecting a Multiline Terminal to a PC using a CT(U)-R Unit
(Example) shows how the CT(U)-R Unit is connected to the ESI(8)-U( ) ETU
and to the PC. The required AC-2R/AC-3R Unit is not shown.
3.5.1 Installing the CT(U)-R Unit
The CT(U)-R Unit should be installed
after the switches are set.
 When wall mounting the Multiline Terminal, a WM-R Unit must be
used. Refer to Section 13 Wall Mounting Multiline Terminals on page
8-29.
Figure 9-24 CT(U)-R Unit
Figure 9-25 Connecting a Multiline Terminal to a PC using a CT(U)-R Unit (Example)
Line Cord (2-line)
Optional Headset
ESI
ETU
Multiline Terminal + CT(U)-R Unit
USB Cable
CT(U)-R Unit
PC