NEC ELECTRA ELITE IPK II - Connection Example; Quick Setup and Configuration Procedures

Electra Elite IPK II Document Revision 3
System Hardware Manual 9 - 35
___________________________________________________________________________________
___________________________________________________________________________________
3.7.4 Connection Example
Refer to Figure 9-37 Connection Example.
3.7.5 Quick Setup and Configuration Procedures
This section provides step-by-step procedures for setting up and
configuring the
IP-R Unit.
1. Connect the LAN port of the IP-R Unit to the network and the
PC port to an optional PC at your workstation. Plug in the
AC-R Unit.
2. The IP-R Unit automatically attempts to locate the DHCP
server when powered up. Wait until the server lookup times
out, and
DHCP Server is Not Found is displayed on the
terminal, and then begin programming.
Figure 9-37 Connection Example
LAN/WAN
Electra Elite IPK II
IAD(8)-U( ) ETU
Megaco Station
Personal Computer
Note 1
LAN Connection
(Straight) Note 2
Connector for PC Connection
Note 1: The IP-R Unit is equipped with a switching Hub function, enabling connection to personal
computers.
Note 2: When using 10 Base-T, a straight cable category 3 or higher is required (maximum length 100
meters). When using 100 Base-TX, a straight cable category 5 or higher is required (maximum
length 100 meters).
AC Adapter
AC Adapter Connection