NEC ELECTRA ELITE IPK II - Page 442

___________________________________________________________________________________
9 - 36 Installing Electra Elite IPK II Optional Terminal Equipment
___________________________________________________________________________________
Document Revision 3 Electra Elite IPK II
3. Press Hold, Transfer,
, , and # to enter the basic programming
mode.
4. The
Programming Menu is displayed. Press 1 to display the
Network Settings options. This enables you to configure IP
settings for IP Terminals.
5. Press 1 (DHCP mode is displayed). Press the corresponding
digit (
1 or 2) to enable or disable DHCP mode; then press the
softkey that corresponds to
Set on the LCD.
6. When DHCP is not used (Static IP assignment), select
1
(Disable), then select
Set, and proceed to step 7. When DHCP
is used, select
2 (Enable - factory default) and proceed to step
10.
7. From the
Network Settings option, press 2 and enter the IP
Address (XXX.XXX.XXX.XXX); then press the softkey

that corresponds to
Set on the LCD.
8. From the
Network Settings option, press 3 and enter the
Subnet Mask (XXX.XXX.XXX.XXX); then press
the softkey that
corresponds to
Set on the LCD.
9. From the
Network Settings option, press 4 and enter the Router
IP Address (XXX.XXX.XXX.XXX); then press
the softkey that
corresponds with
Set on the LCD. To return to Programming
Menu
, press the softkey that corresponds to Prev on the LCD.
10. Press 2 from the
Programming Menu to access the MGC
(Media Gateway Controller) IP Address and enter the IP
Address for IAD(8)-U( ) or PVA ETU Megaco Station
(XXX.XXX.XXX.XXX); then press the softkey that corresponds
to
Set on the LCD.
11. Press 3 from the
Programming Menu to access the Extension
Number
option. Enter the extension number and press the
softkey that corresponds to
Set on the LCD.
12. The extension number is used to register the IP terminal with
the IAD(8)-U( ) Megaco Station Card or PVA ETU. These
settings must match the Electra Elite IPK II Programming
Station Number Assignment in PRG 11-02.
This entry is
required if DHCP mode is enabled
.