NEC ELECTRA ELITE IPK II - Section 10 Installing a Button Set on a Multiline Terminal

Electra Elite IPK II Document Revision 3
System Hardware Manual 8 - 25
___________________________________________________________________________________
___________________________________________________________________________________
SECTION 10 INSTALLING A BUTTON SET ON A MULTILINE TERMINAL
The BS( )-R Unit button set can be installed on a Multiline Terminal to accommodate
French and Spanish languages. The keypad provides the appropriate language
designations.
1. Remove the plastic cover. (Refer to paragraph 8.2 Removing the Plastic Panel
on page 8-23.)
2. Pull up on the tab and lift the button pad away from the telephone to remove the
existing button.
3. Slide the new button set into the grooves located on the inside of the telephone,
then press down on the button set to snap it into place.
4. Insert the line card and plastic panel on the Multiline Terminal.
Figure 8-29 Removing the Button Set from a Multiline Terminal
Figure 8-30 Inserting a New Button Set into a Multiline Terminal