NEC ELECTRA ELITE IPK II - Applying Power to IP Terminals

___________________________________________________________________________________
8 - 16 Installing Electra Elite IPK Multiline Terminals
___________________________________________________________________________________
Document Revision 3 Electra Elite IPK II
SECTION 4APPLYING POWER TO IP TERMINALS
The ITH-8D/16D-2 terminals support two different methods to power the terminal:
J AC-2R/AC-3R
Plug the optional AC-2R/AC-3R AC Adapter input Jack in the terminal base unit,
and plug the 2-prong wall plug of the AC Adapter in a standard 120 Vac wall
outlet.
J In-Line Power/POE (Power Over Ethernet)
In-Line Power (sometimes called Power Over Ethernet) is a LAN technology
that allows standard 10/100 Base-T data cables to pass electrical current from a
power source to a requesting end device.
Refer to Table 8-1 Power Configuration Switch Settings (ITH-3) and Figure 8-17
Switch SW2 Position to allow different power sources for the ITH-8D/16D-3
terminals.
J Power Configuration Switch Settings
Figure 8-16 Plug in AC-2R/AC-3R Adapter
Table 8-1 Power Configuration Switch Settings (ITH-3)
Power Method Equipment Used
Switch SW2
Position
NEC AC Adapter AC-2R, AC-3R 1
IEEE 802.3af any IEEE 802.3af compliant equipment
Cisco Equipment
(CDP)
Cisco In-Line Power Switches 2