NEC ELECTRA ELITE IPK II - Section 15 Wall Mounting a Multiline Terminal

Electra Elite IPK II Document Revision 3
System Hardware Manual 8 - 43
___________________________________________________________________________________
___________________________________________________________________________________
SECTION 15 WALL MOUNTING A MULTILINE TERMINAL USING THE WALL MOUNT UNIT
(WM-R U
NIT)
The Wall Mount Unit is used to attach any DTH/DTR/IP connection Multiline Terminal
(except the DTR-2DT-1 TEL and the ITR-4D-3 TEL) to the wall. This unit connects to
the back side of the telephone.
When adapters are used, the Multiline Terminal must be installed on the wall using
the WM-R Unit.
1. Plug line cord in the wall receptacle. Leave about eight inches of cord and
bundle the rest.
2. Feed the line cord through the opening in the wall mount unit as illustrated in
Figure 8-61 Attaching the Wall Mount Unit to the Wall.
3. Attach the WM-R Unit using six screws.
4. Install the Multiline Terminal over the four tabs on the base cover, and push
down until it clicks in place as illustrated in Figure 8-62 Attaching the Multiline
Terminal to the Wall Mount Unit.
Figure 8-61 Attaching the Wall Mount Unit to the Wall