___________________________________________________________________________________
8 - 42 Installing Electra Elite IPK Multiline Terminals
___________________________________________________________________________________
Document Revision 3 Electra Elite IPK II
2. Connect the Base Cover to the wall as shown on Figure 8-59
Using Screws to Attach Base Cover To Wall.
3. Install the terminal on the Base Cover as shown on Figure 8-60
Connecting Terminal to the Base Cover. To remove the
Terminal from the wall, press the knob used to unlatch the base
cover and push the terminal up until it disconnects.
Figure 8-59 Using Screws to Attach Base Cover To Wall
Figure 8-60 Connecting Terminal to the Base Cover
To Next Page
Loading...
