NEC ELECTRA ELITE IPK II - Installing Flash Drive on the VMP( )-U40 ETU

Electra Elite IPK II Document Revision 3
System Hardware Manual 6 - 123
___________________________________________________________________________________
___________________________________________________________________________________
7.5.3 Installing Flash Drive on the VMP( )-U40 ETU
Use the following instructions to install the Flash Drive.
1. Remove the VMP( )-U40 ETU and selected Flash Drive from
the box.
2. Locate slot CN6 on VMP( )-U40 ETU.
3. The side with the SanDisk name in large red letters should be
facing up, as shown in Figure 6-68 Installing the Flash Drive on
the VMP( )-U40 ETU.
 The Flash Drive goes in only one way, and does not take much
force to insert it.
Figure 6-68 Installing the Flash Drive on the VMP( )-U40 ETU