NEC ELECTRA ELITE IPK II - Installing the External Microphone

___________________________________________________________________________________
9 - 28 Installing Electra Elite IPK II Optional Terminal Equipment
___________________________________________________________________________________
Document Revision 3 Electra Elite IPK II
2. Plug the tabs marked
A and B into adapter slots, then snap the
tab on the other end of the adapter into the receptacle marked
C. Refer to Figure 9-28 Attaching the HF-R Unit to the Multiline
Term in al.
3. Replace the base plate (or wall mount unit) and attach the line
cord. Refer to Section 3 Connecting a Multiline Terminal to the
System on page 8-15.
3.6.2 Installing the External Microphone
An external microphone can be installed on the HFU-U Unit. These
instructions apply to the external microphone obtained from NEC.
The microphone is equipped with a locking mute button and a red
LED indicator that is off when the microphone is in mute.
1. Plug the microphone cord into the jack on the HF-R Unit.
 The microphone should be one~three feet away from the
Multiline Terminal with the Mic grate facing the user.
Figure 9-29 Microphone with Mute