NEC ELECTRA ELITE IPK II - Section 12 Removing or Installing the Base Plate on a Multiline Terminal; Removing the Base Plate

Electra Elite IPK II Document Revision 3
System Hardware Manual 8 - 27
___________________________________________________________________________________
___________________________________________________________________________________
SECTION 12 REMOVING OR INSTALLING THE BASE PLATE ON A MULTILINE TERMINAL
DTH/DTR/ITH Multiline Terminals come equipped with a base cover.
12.1 Removing the Base Plate
1. Extend the base plate to maximum height.
2. Press the tabs as illustrated in Figure 8-33 Removing Base Plate, and
slide the base cover in the direction of the arrows until it clicks.
Figure 8-33 Removing Base Plate