NEC ELECTRA ELITE IPK II - Connecting the Printer to the KSU; Pgd(2)-U10 Adp; Using a PGD(2)-U10 ADP

Electra Elite IPK II Document Revision 3
System Hardware Manual 7 - 3
___________________________________________________________________________________
___________________________________________________________________________________
5.2 Connecting the Printer to the KSU
When using the charge control, connect the printer to the KSU to allow printing
of the charge data. Connect the printer to the serial port on the side of the
KSU with a DB9 straight cable. Use the COM 1 port to connect the printer.
SECTION 6 PGD(2)-U10 ADP
6.1 Using a PGD(2)-U10 ADP
The PGD(2)-U10 ADP (adapter) provides two circuits that allow connection to
external terminals such as:
J Door Box (eight maximum per system)
J External Speaker with Amplifier (eight maximum with PGD(2)-U10 ADP)
J External Music Source (external MOH) (96 maximum per system)
J External Recording System (96 maximum per system)
J External Ringing
Figure 7-2 Connecting a PC to the KSU