NEC ELECTRA ELITE IPK II - Direct Wall Mounting

Electra Elite IPK II Document Revision 3
System Hardware Manual 13 - 23
___________________________________________________________________________________
___________________________________________________________________________________
8.7 Direct Wall Mounting
When a standard wall plate is not available, mount the telephone directly on
the wall. Before mounting the telephone, consider the following:
J Select a location away from electrical cables, pipes, or other items
behind the mounting location that could cause a hazard when inserting
screws into the wall.
J Make sure the wall material can support the weight of the base unit.
J Use #10 screws with anchoring devices suitable for the wall material.
To mount the telephone:
1. Insert two mounting screws 3-15/16 inches apart. Allow about 3/16 of an
inch between the wall and screw heads for mounting the telephone.
2. Plug in and secure the AC adapter.
3. Plug the AC adapter into the base unit.
4. Plug one end of the short telephone cord in the
LINE In JACK on the
base unit. Then plug an Electra Elite IPK multiline terminal line in the
LINE OUT jack. Place the telephone cords inside the molded channels
on the bottom of the wall mount stand.
Figure 13-19 Inserting Screws into the Wall for Wall Mounting the
Telephone