NEC ELECTRA ELITE IPK II - Attendant Stations; Chapter 4; General Information; Programming from a PC

System Hardware Manual 4 - 1
___________________________________________________________________________________
___________________________________________________________________________________
Hardware Requirements Chapter 4
SECTION 1GENERAL INFORMATION
The technician should be familiar with the Electra Elite IPK II system before trying to
install it. Review this chapter carefully.
SECTION 2PROGRAMMING STATIONS
Any multiline station can be a programming station in the Electra Elite IPK II system.
Station equipment connected to any port of an ESI(8)-U( ) ETU can be a
programming position, but requires a display multiline terminal.
SECTION 3ATTENDANT STATIONS
Any display Multiline Terminal can be programmed as an Attendant position in the
Electra Elite IPK II system. An Attendant Position can have up to four DCR-60-1
Consoles attached. Each Attendant Console must be supported by an ESI(8)-U( )
ETU. A maximum of four Attendant Consoles can be installed in each Electra Elite
IPK II system.
SECTION 4PROGRAMMING FROM A PC
Electra Elite IPK II systems can be programmed using a personal computer. The
available Graphical User Interface allows the technician/end-user easy access to all
information that can be programmed on the Electra Elite IPK II system. The PC must
be a Pentium III 600 MHz or higher PC and have a Windows operating system
compatible with the PC Programming (PCPro) application.