NEC ELECTRA ELITE IPK II - Connecting Cables to the AD(A)-R Unit

Electra Elite IPK II Document Revision 3
System Hardware Manual 9 - 7
___________________________________________________________________________________
___________________________________________________________________________________
3.2.1 Connecting Cables to the AD(A)-R Unit
The first step in installing the AD(A)-R Unit is to connect the cables
between the recording device and the AD(A)-R Unit.
Cable terminal connectors are located on the side of the AD(A)-R
Unit. Cables should be connected on this unit
before installing the
unit on the Multiline Terminal.
Cables can be connected to determine whether or not pause control
is provided for the recording.
To connect the cables:
1. Cut off the plug on one end of the cable.
2. Remove the screw as illustrated in Figure 9-10 Removing
AD(A)-R Unit Cover and open the unit cover.
Figure 9-8 AD(A)-R Unit Connection without Pause Control
Figure 9-9 AD(A)-R Unit Connection with Pause Control
Mini-Plug Mini-Plug
Connection Cord
AD(A)-R Unit
Recording
Device
Earphone CN2
Mini-Plug Mini-Plug
Connection Cord
AD(A)-R Unit
Recording
Device
Mini-Plug Mini-Plug
Connection Cord
T6 (Shielded Wire)
T7 (Wire)
Line In CN2
Remote