NEC ELECTRA ELITE IPK II - Section 13 Wall Mounting Multiline Terminals; Wall Mounting a Multiline Terminal Using the Base Plate; Adjusting the Hanger Hook

Electra Elite IPK II Document Revision 3
System Hardware Manual 8 - 29
___________________________________________________________________________________
___________________________________________________________________________________
SECTION 13 WALL MOUNTING MULTILINE TERMINALS
You can wall mount a DTH/DTR/IP connection Multiline Terminal (except for
DTR-2D-1 TEL) using the base cover or an optional wall mount unit. A wall mount
unit must be used if adapters are installed on the Multiline Terminal.
13.1 Wall Mounting a Multiline Terminal using the Base Plate
13.1.1 Adjusting the Hanger Hook
1. Remove the hook from the unit.
2. Turn the hook with the tab toward the top.
3. Slide the hook until it glides into position forming the hanger
hook for the handset.
Figure 8-35 Removing the Hanger Hook on a Multiline Terminal
Figure 8-36 Sliding the Hanger Hook into Position
Hanger Hook