NEC ELECTRA ELITE IPK II - Connectors; LED Indications

Electra Elite IPK II Document Revision 3
System Hardware Manual 6 - 41
___________________________________________________________________________________
___________________________________________________________________________________
5.6.4 LED Indications
Refer to Table 6-15 COIB(8)-U20/30 ETU LED Indications.
5.6.5 Connectors
The following connector is included:
J CN1 Connects to the backplane.
Reset N/A Resets the
COIB(8)-U20/U30
ETU.
Table 6-15 COIB(8)-U20/30 ETU LED Indications
LED Description On Flashing Off
LIVE ETU status Operation
Stopped (Power
On)
Normal
Operation
No
Power
LED 1 Channel 1 status Busy Not Used Idle
LED 2 Channel 2 status Busy Not Used Idle
LED 3 Channel 3 status Busy Not Used Idle
LED 4 Channel 4 status Busy Not Used Idle
LED 5 Channel 5 status Busy Not Used Idle
LED 6 Channel 6 status Busy Not Used Idle
LED 7 Channel 7 status Busy Not Used Idle
LED 8 Channel 8 status Busy Not Used Idle
Table 6-14 COIB(8)-U20/U30 ETU Default Switch/Jumper Settings
Switch/
Jumper
Setting Description