NEC ELECTRA ELITE IPK II - Installing AP(A)-R or AP(R)-R Unit on a Multiline Terminal

___________________________________________________________________________________
9 - 16 Installing Electra Elite IPK II Optional Terminal Equipment
___________________________________________________________________________________
Document Revision 3 Electra Elite IPK II
3.3.2 Installing AP(A)-R or AP(R)-R Unit on a Multiline Terminal
The AP(A)-R or AP(R)-R Unit should be installed
after the switches
are set.
 When wall mounting the Multiline Terminal, a WM-R Unit must be
used. Refer to Section 13 Wall Mounting Multiline Terminals on page
8-29.
1. Prepare Multiline Terminal for adapter installation. Refer to
Section 2 Preparing Multiline Terminal for Adapter Installation
on page 9-1.
2. Plug the tabs marked
A and B into adapter slots, then snap the
tab on the other end of the adapter into the receptacle marked
C. Refer to Figure 9-17 Attaching the AP(A)-R/AP(R)-R Unit to
the Multiline Terminal.