NEC ELECTRA ELITE IPK II - Page 407

System Hardware Manual 9 - 1
___________________________________________________________________________________
___________________________________________________________________________________
Installing Electra Elite IPK II
Optional Terminal Equipment
Chapter 9
SECTION 1GENERAL INFORMATION
The Electra Elite IPK II system provides several adapters that allow peripheral
equipment to be attached to the Multiline Terminals. This optional equipment
enhances the Electra Elite IPK II system and can be purchased separately as a
customer business grows. Each Multiline Terminal (except DTR-2DT-1) can have up
to two adapters installed at the same time. Only one IP-R Unit or IPW-2U Unit is
allowed per terminal. This chapter describes each adapter and provides applicable
installation instructions.
SECTION 2PREPARING MULTILINE TERMINAL FOR ADAPTER INSTALLATION
To prepare the Multiline Terminal for adapter installation:
1. Unplug the telephone line from the terminal.
2. Grasp in the middle of the hollow spaces at the top and pull up until the retaining
tabs click to raise the base plate. Refer to Figure 9-1 Raising the Base Plate.
Figure 9-1 Raising the Base Plate