___________________________________________________________________________________
9 - 2 Installing Electra Elite IPK II Optional Terminal Equipment
___________________________________________________________________________________
Document Revision 3 Electra Elite IPK II
3. Press down on the tabs indicated in Figure 9-2 Removing the Multiline Terminal
Base Plate, and push forward on the base plate to remove it.
4. When an adapter is installed for the first time, the base cover on the Multiline
Terminal must be modified. Two adapters can be installed in the Multiline
Terminal, and two separate cutouts are provided. Remove the applicable cutout/
cutouts on the bottom of the base plate. When only one adapter is being
installed and it needs an AC-2R/AC-3R Unit for power, remove only the right
cutout as shown in Figure 9-3 Modifying Base Plate for Adapter Installation.
Figure 9-2 Removing the Multiline Terminal Base Plate
To Next Page
Loading...
