NEC ELECTRA ELITE IPK II - LED Indications

___________________________________________________________________________________
6 - 140 Installing ETUs (Circuit Cards)
___________________________________________________________________________________
Document Revision 3 Electra Elite IPK II
7.6.4 LED Indications
Refer to Table 6-49 VMS(2)/(4)/(8)-U( ) ETU LED Indications.
Table 6-49 VMS(2)/(4)/(8)-U( ) ETU LED Indications
LED Description On Flashing Off
LIVE ETU status Receiving
power
Not Used No Power
CH1 Port status Busy Not Used Idle/Not used
CH2 Port status Busy Not Used Idle/Not used
CH3 Port status Busy Not Used Idle/Not used
CH4 Port status Busy Not Used Idle/Not used
CH5 Port status Busy Not Used Idle/Not used
CH6 Port status Busy Not Used Idle/Not used
CH7 Port status Busy Not Used Idle/Not used
CH8 Port status Busy Not Used Idle/Not used
MB MB Switch
status
ON Not Used OFF
BIOS BIOS Error
Status
BIOS Error Not Used No error
BCLR Application
status
Red:
DOS started
(VM not
ready)
Green:
VM running
Orange:
Error
Not Used Idle
 When BCLR LED is orange, check error type on console
screen. After error is corrected, LED automatically changes to
green. Do Not connect link between console and ETU until
BCLR turns green during booting.
HDD Hard Disk
status
Not Used Hard Disk
active
Hard Disk
inactive
 Do not reset the ETU while the HDD LED is flashing.