NEC ELECTRA ELITE IPK II - Removing the Wall Mounted Multiline Terminal from the Base Plate; Wall Mounting the Base Plate on a Switch Box

Electra Elite IPK II Document Revision 3
System Hardware Manual 8 - 33
___________________________________________________________________________________
___________________________________________________________________________________
13.1.3 Removing the Wall Mounted Multiline Terminal from the Base Plate
To remove the Multiline Terminal, press the tabs at the bottom as
shown in Figure 8-43 Removing the Multiline Terminal, and push up
on the Telephone until it comes loose.
13.1.4 Wall Mounting the Base Plate on a Switch Box
1. Locate the screw holes on the base cover and hang the cover
over the screws on the switch box as illustrated in Figure 8-44
Wall Mounting Base Plate on Switch Box.
Figure 8-43 Removing the Multiline Terminal
Figure 8-44 Wall Mounting Base Plate on Switch Box