NEC ELECTRA ELITE IPK II - Connectors; Jumper Settings

___________________________________________________________________________________
6 - 96 Installing ETUs (Circuit Cards)
___________________________________________________________________________________
Document Revision 3 Electra Elite IPK II
7.1.5 Connectors
The following connectors are included:
J J2 and J3
Used to install the MDM-F-20 Unit.
J J9
Connects to the backplane.
J 9-pin RS-232 (COM2)
Connector is not used (MDM-F-20 Unit).
J RJ-11 modem port (COM2)
Remote connector on serial interface (MDM-F-20 Unit).
J 9-pin RS-232 (COM1)
Local serial connector on main ETU for direct connection.
7.1.6 Jumper Settings
7.1.7 Connectors
The following connectors are included:
J J2 Connects to the backplane.
J J6 Used for Compact flash drive on FMS.
J J10 Not used.
J J11) COM port for console programming connection
J J12 Port expansion connector for DSP-U30
J1 Used only on FMS/CMS
Pin 1 to Pin 2 No external modem connected (default)
Pin 2 to Pin 3 External modem connected