NEC ELECTRA ELITE IPK II - Switch Settings

Electra Elite IPK II Document Revision 3
System Hardware Manual 9 - 15
___________________________________________________________________________________
___________________________________________________________________________________
3.3.1 Switch Settings
The AP(A)-R Unit and AP(R)-R Unit have three switch locations.
Refer to Table 9-3 AP(A)-R/AP(R)-R Unit Switch Settings for a
description of each switch and an explanation of the settings.
Figure 9-16 AP(A)-R Unit/AP(R)-R Unit Switches
Table 9-3 AP(A)-R/AP(R)-R Unit Switch Settings
Switch Description/Settings
SW1
SW1-1 Connects to Multiline Terminal (Default).
SW1-2 Not Used
SW3
SW3-1 Sets impedance to 600 Ω for devices such as
modems or facsimile machines.
SW3-2 Used for complex impedance devices such as
Single Line Telephones.
Dip
Switch
es
(DSW)
DSW
1~8
Leave switches at default.