NEC ELECTRA ELITE IPK II - Wall Mounting the PGD(2)-U10 ADP (Optional)

___________________________________________________________________________________
7 - 10 Installing Electra Elite IPK II KSU Common Optional Equipment
___________________________________________________________________________________
Document Revision 3 Electra Elite IPK II
9. Install a modular jack for each PGD(2)-U10 ADP. For each module, run
one-pair 24 AWG station cable from the crossconnect block to a modular
jack. Ground the unused pair.
10. Terminate the extension leads to GRN/RED of the modular jack.
Terminate the unused leads to the jack.
11. Install bridging clips as required.
 For the module to ID correctly, set the circuit type to 0 for the port in
Program 10-03-01 prior to connecting the line cord.
12. Plug a modular line cord from the mod jack to the CN1 connector on the
PGD(2)-U10 ADP.
6.4 Wall Mounting the PGD(2)-U10 ADP (Optional)
1. To wall mount the PGD(2)-U10 ADP, insert two wood screws 100mm
apart (3 15/16”). Leave 3mm (1/8”) of the screw exposed. The screws
can be installed either vertical or horizontal, depending on which position
fits best for your location.
Figure 7-9 PGD(2)-U10 ADP Connections
CN3
Channel 2 CN3
Channel 1
RCA
Plugs
CN1
(to ESIU port)