Electra Elite IPK II Document Revision 3
System Hardware Manual 7 - 9
___________________________________________________________________________________
___________________________________________________________________________________
6. Repeat Steps 4 and 5 for any additional connections required.
7. Replace the cover and tighten the screw to hold the cover in place.
8. When required for the function being used, insert the RCA connectors in
the CN3 (Channel 1) and CN3 (Channel 2) connectors on the back of the
PGD(2)-U10 ADP.
Figure 7-8 Connecting Cable to the PGD(2)-U10 ADP
Flat-head screwdriver
Press down
Cable
CN4, CN5
To Next Page
Loading...
