NEC ELECTRA ELITE IPK II - Jumper Settings; VMP( )-U40 LED Indications

Electra Elite IPK II Document Revision 3
System Hardware Manual 6 - 133
___________________________________________________________________________________
___________________________________________________________________________________
7.5.7 Jumper Settings
7.5.8 VMP( )-U40 LED Indications
Table 6-43 VMP( )-U40 ETU Jumper Settings
J1
1-2 External modem not connected (default)
2-3 External modem connected
J7
1-2 Compact Flash is master drive
2-3 HDD is master drive (default)
Table 6-44 VMP( )-U40 ETU LED Indications (on back of ETU)
LED No. Name On Flashing Off
1
AP1
Application
Software
Green (Run no
errors)
Amber (Run
with errors)
Red (Not
running)
Not Used Not Used
2 AP2 Not Used Not Used Not Used
3 DRIVE access Red for access Not Used Not accessed
4CF POWER
Red
(Receiving
ETU power)
Not Used No ETU power
5 LIVE Not Used
Red every
125ms during
operation
Operation
shutdown
6SW3 in RUN
Red (don’t
remove ETU)
Not Used Not in RUN
7
SW3 in
SHUTDOWN
Red (ETU can
be removed)
Not Used
Not
SHUTDOWN
8Power
Red (ETU
Receiving KSU
power)
Not Used No KSU power
9
Development
only
Not Used Not Used Not Used
10 CH1 Red (Off-Hook) Not Used On-Hook
11 CH2 Red (Off-Hook) Not Used On-Hook