NEC ELECTRA ELITE IPK II - Installing the CT(A)-R Unit

___________________________________________________________________________________
9 - 20 Installing Electra Elite IPK II Optional Terminal Equipment
___________________________________________________________________________________
Document Revision 3 Electra Elite IPK II
3.4.1 Installing the CT(A)-R Unit
The CT(A)-R Unit should be installed
before connecting the PC and
before connecting the ESI port to the Multiline Terminal.
 When wall mounting the Multiline Terminal, a WM-R Unit must be
used. Refer to Section 13 Wall Mounting Multiline Terminals on page
8-29.
1. Prepare Multiline Terminal for adapter installation. Refer to
Section 2 Preparing Multiline Terminal for Adapter Installation
on page 9-1.
2. Plug the tabs marked
A and B into adapter slots, then snap the
tab on the other end of the adapter into the receptacle marked
C. Refer to Figure 9-21 Attaching the CT(A)-R Unit to the
Term in al.