NEC ELECTRA ELITE IPK II - External Recording System or External Ringer

Electra Elite IPK II Document Revision 3
System Hardware Manual 7 - 17
___________________________________________________________________________________
___________________________________________________________________________________
6.8.2 Connecting a Dry Contact Relay Device to the PGD(2)-U10 ADP
 Make sure the jumper in the PGD(2)-U10 ADP for the channel is set
correctly. (Refer to Figure 7-6 Jumper Settings).
1. If a line cord was not previously connected to the PGD(2)-U10
ADP, complete Steps 2~5. Otherwise, skip to Step 6.
2. Install a modular jack for each
PGD(2)-U10 ADP. Run one-pair
24 AWG station cable from the crossconnect block to a
modular jack. Ground the unused pair.
3. Terminate the extension leads to GRN/RED of the modular
jack. Terminate the unused leads to the jack.
4. Install bridging clips as required.
5. Plug a modular line cord from the mod jack to the CN1
connector on the
PGD(2)-U10 ADP.
6. Connect the two-conductor station cable from the CN5
connectors in the
PGD(2)-U10 ADP to the external relay.
 The relay closes when the Door Box/external page zone is
called. The maximum applied voltage is 24vDC at .5A for each
contact.
6.9 External Recording System or External Ringer
The PGD(2)-U10 ADP allows for the connection of an external recording system
or external ringer.
1. Make sure the jumper in the
PGD(2)-U10 ADP for the channel is set
correctly. (Refer to Figure 7-6 Jumper Settings).
2. If a line cord was not previously connected to the
PGD(2)-U10 ADP,
complete Steps 3~6. Otherwise, skip to Step 7.
3. Install a modular jack for each
PGD(2)-U10 ADP. Run one-pair 24 AWG
station cable from the crossconnect block to a modular jack. Ground the
unused pair.
4. Terminate the extension leads to GRN/RED of the modular jack.
Terminate the unused leads to the jack.
5. Install bridging clips as required.