Electra Elite IPK II Document Revision 3
System Hardware Manual 7 - 7
___________________________________________________________________________________
___________________________________________________________________________________
4. Strip one end of the cable to be connected to the control relay or door
box so that approximately 1/4â (8 mm) of bare wire is exposed.
5. Insert the cable in the proper CN4 or CN5 location while holding down
the lock button with a flat-head screwdriver. After the cable is in place,
release the lock button.
î
Refer to the specific function being connected for more detail on
PGD(2)-U10 ADP connections.
Figure 7-6 Jumper Settings
Short setting
Open setting
S6
S3
S4
S5
Cable
8mm
To Next Page
Loading...
