NEC ELECTRA ELITE IPK II - Connecting the Base Unit

Electra Elite IPK II Document Revision 3
System Hardware Manual 13 - 3
___________________________________________________________________________________
___________________________________________________________________________________
3.3 Connecting the Base Unit
1. Connect the AC adapter to the DC IN 9 V jack and to a standard 120V
AC wall outlet.
2. Set the base on a desk or tabletop, and place the handset in the base
unit as shown.
Figure 13-2 Connecting the D
term
Headset
Cordless Base Unit to the Adapter
Figure 13-3 Raising the Antenna on the D
term
Headset Cordless Base Unit
To DC IN 9V
AC Adapter
(supplied)
To AC Outlet
Route the cord