NEC ELECTRA ELITE IPK II - Connecting Cables to the ADA-U Unit

Electra Elite IPK II Document Revision 3
System Hardware Manual 11 - 9
___________________________________________________________________________________
___________________________________________________________________________________
3.2.2 Connecting Cables to the ADA-U Unit
Cable terminal connectors are located on the right side of the ADA-U
Unit. Cables should be connected on this unit before installing the
unit on the Multiline Terminal.
1. Cut off the plug on one end of the cable.
2. Locate the adapter terminals on the right side of the unit as
illustrated in Figure 11-12 ADA-U Unit.
3. Remove the cap on the adapter terminal to expose the metal
receptacle. Push the cable in the applicable receptacle, and
replace the cap. Line up the slot on the cap with the slot on the
metal receptacle to ensure proper contact. Refer to
Figure 11-13 Attaching Cables to the ADA-U Unit.
Figure 11-12 ADA-U Unit
Figure 11-13 Attaching Cables to the ADA-U Unit
Terminals