NEC ELECTRA ELITE IPK II - Installing Built-In and External Batteries in the KSU; Built-In Battery Installation

Electra Elite IPK II Document Revision 3
System Hardware Manual 5 - 27
___________________________________________________________________________________
___________________________________________________________________________________
3.11 Installing Built-In and External Batteries in the KSU
3.11.1 Built-In Battery Installation
1. Connect the two batteries in series as shown in Figure 5-27
Connecting Built-In Batteries. The red cord attaches to the red
terminal and the black cord attaches to the black terminal.
2. Install the batteries into the bottom space at the left side the
KSU. Refer to Figure 5-28 Placing the Batteries into the KSU.
Figure 5-26 PSU Fuse Replacement
Figure 5-27 Connecting Built-In Batteries
F101 (DC In) F1 (AC In)
Be careful, and properly connect the
terminals of the batteries.