NEC ELECTRA ELITE IPK II - Page 414

___________________________________________________________________________________
9 - 8 Installing Electra Elite IPK II Optional Terminal Equipment
___________________________________________________________________________________
Document Revision 3 Electra Elite IPK II
3. Locate the adapter terminals on the unit.
4. Remove the cap on the adapter terminal to expose the metal
receptacle. Push the cable in the applicable receptacle, and
replace the cap. Line up the slot on the cap with the slot on the
metal receptacle to ensure proper contact. Refer to Figure 9-11
Attaching Cables to the AD(A)-R Unit.
Attach the cables to the AD(A)-R Unit according to Table 9-1
AD(A)-R Unit Cable Connections.
Figure 9-10 Removing AD(A)-R Unit Cover
Figure 9-11 Attaching Cables to the AD(A)-R Unit
Remove Screw