NEC ELECTRA ELITE IPK II - Page 367

Electra Elite IPK II Document Revision 3
System Hardware Manual 8 - 15
___________________________________________________________________________________
___________________________________________________________________________________
SECTION 3CONNECTING A MULTILINE TERMINAL TO THE SYSTEM
This instruction applies to all DTH/DTR/IP Electra Elite IPK Multiline Terminals except
DTR-2DT-1 TEL.
1. Plug the telephone cord into the modular jack on the bottom side of the Multiline
Terminal. The handset is also attached to the bottom side of the Multiline
Terminal.
2. Lead the telephone and handset cords through the applicable grooves.
Figure 8-14 Connecting a Multiline Terminal to the System
Figure 8-15 Leading Line Cords on a Multiline Terminal