___________________________________________________________________________________
6 - 124 Installing ETUs (Circuit Cards)
___________________________________________________________________________________
Document Revision 3 Electra Elite IPK II
4. Push the drive in until it is fully seated, as shown in Figure 6-69
Flash Drive Seated on VMP( )-U40 ETU.
5. Ensure that jumper J1 is set across pins 1 and 2.
6. Ensure that jumper J7 is set across pins 1 and 2.
7. Insert Sony battery CR-2032 into BATT1 connector with the +
sign facing up as shown in Figure 6-69 Flash Drive Seated on
VMP( )-U40 ETU on page 6-124. When an eight port ETU is
used go to 7.5.5 Installing DSP( )-U30 on VMP( )-U40 ETU on
page 6-129, otherwise your voice mail ETU is ready for
installation.
Figure 6-69 Flash Drive Seated on VMP( )-U40 ETU
To Next Page
Loading...
