___________________________________________________________________________________
9 - 34 Installing Electra Elite IPK II Optional Terminal Equipment
___________________________________________________________________________________
Document Revision 3 Electra Elite IPK II
4. Plug the IP-R Unit in Connector 1 on the Multiline Terminal
(DTH-8D/16D/32D-1/2) as shown in Figure 9-35 Plugging in
the IP-R Unit.
5. Attach the base plate by lining up the four tabs on the base
cover with corresponding slots on the terminal as shown in
Figure 9-36 Attaching the Base Plate, and slide the cover in the
direction of the arrows until it clicks in place.
Figure 9-35 Plugging in the IP-R Unit
Figure 9-36 Attaching the Base Plate
IP-R Unit
Connector 1
Optional
Connector
To Next Page
Loading...
