NEC ELECTRA ELITE IPK II - Page 431

Electra Elite IPK II Document Revision 3
System Hardware Manual 9 - 25
___________________________________________________________________________________
___________________________________________________________________________________
1. Prepare Multiline Terminal for adapter installation. Refer to
Section 2 Preparing Multiline Terminal for Adapter Installation
on page 9-1.
2. Plug the tabs marked
A and B into adapter slots, then snap the
tab on the other end of the adapter into the receptacle marked
C. Refer to Figure 9-26 Attaching the CT(U)-R Unit to the
Multiline Terminal.
3. Replace the base plate (or wall mount unit) and attach the line
cord. Refer to Section 3 Connecting a Multiline Terminal to the
System on page 8-15.
Figure 9-26 Attaching the CT(U)-R Unit to the
Multiline Terminal