NEC ELECTRA ELITE IPK II - Page 268

___________________________________________________________________________________
6 - 126 Installing ETUs (Circuit Cards)
___________________________________________________________________________________
Document Revision 3 Electra Elite IPK II
3. Check jumper J-1 and make sure it is on pins 1-2. Refer to
Figure 6-71 Plus Sign on Battery Displayed Up.
4. Insert Sony battery CR-2032 into BATT1 connector, the
+ sign
should be facing up as shown in Figure 6-71 Plus Sign on
Battery Displayed Up.
5. Insert keyed end of ribbon cable into connector CN8, the keyed
connector only goes into connector CN8 one way and should
not be forced. The red stripe of the cable is towards the bottom
of the ETU as shown in Figure 6-72 Connecting the Ribbon
Cable on page 6-127.
Figure 6-71 Plus Sign on Battery Displayed Up
J-1 — make sure
it is set to pins
2-3.
J-7 — make sure
it is set to pins 2-
3 for hard drive.
BATT1 Connector
— install battery
with the
+ facing
up.