Electra Elite IPK II Document Revision 3
System Hardware Manual 6 - 127
___________________________________________________________________________________
___________________________________________________________________________________
6. Place hard drive on table with printed circuit board side up and
the pins facing the card as shown in Figure 6-72 Connecting
the Ribbon Cable.
7. Connect the hard drive to the cable making sure that the four
pins on right side of the drive are not connected as shown in
Figure 6-73 Leaving Four Pins Unconnected.
Figure 6-72 Connecting the Ribbon Cable
Notice the four pins to
the left of the drive.
These pins are not
connected for normal
operation.
Red Stripe
To Next Page
Loading...
