NEC ELECTRA ELITE IPK II - Page 468

___________________________________________________________________________________
9 - 62 Installing Electra Elite IPK II Optional Terminal Equipment
___________________________________________________________________________________
Document Revision 3 Electra Elite IPK II
3. Plug the interface unit into the right adapter connection as
shown on Figure 9-63 ADM and Multiline Terminal with Base
Covers Removed on the next page.
4. Place the interface unit cable in the cable channels on the ADM
and multiline terminal.
5. Install the connector plate provided with the ADM as shown in
Figure 9-64 Installing the Connector Plate on the next page.
 The connector plate cannot be used with Inaset terminals.
Table 9-12 DSW1 Switch Positions
Series Keyset Name DSW1 Switch Positions
D
term
Series i
DTR/H-(8)/(16)D-2( ) TEL
DTR/H -16LD-2( ) TEL
DTR/H-16D(BL)-2( ) TEL
ON
DSW1
1 2 3 4 5 6 7 8
Figure 9-63 ADM and Multiline Terminal with Base Covers Removed